Drywalls Tools And Equipment For The First Timer

Hanging and mudding drywall can be an intimidating project especially if it's your first time. While you could hire a professional, a small drywall project can be a great first do-it-yourself job to get you familiar with the process. You can find tutorials online or on DVD but here are some basics to get you familiar with drywall installation and mudding.

Having the right drywall equipment is essential. Basic drywall tools aren't expensive so there isn't a large investment and you'll be able to reuse the tools on future projects.

You'll need measuring and fitting tools such a measuring tape, a t-square that is large enough to run the width of a panel of drywall, a plastic or metal corner tool and a leveling tool. To cut the drywall you should use a jigsaw but for small projects that only require right angles, you can use a cutting tool. You'll also need other cutting tools such as a utility knife and other knives of various lengths for finishing.

For putting up the drywall you'll need drywall screws or nails and tools to affix them, such as a hammer and screwdriver or drill. You'll also need an all purpose drywall compound which comes in powder form or premixed as well as a mud pan for mixing the compound. Special paper tape and textured tape is required to hide the seams prior to mudding. You'll also need trowels for applying the compound and sandpaper (course and fine grit) for finishing.

The key to hanging drywall is planning and having patience. Don't rush through it. If you do, it will show in the results. If you take several days the results will look professional.

Take accurate measurements of the area you're going to apply drywall and add a bit more for cutting and waste. Purchase the right drywall for the job. There is special drywall that is moisture resistant which should be used for the bathroom or homes in tropical climates. Measure out the drywall using your t-square to ensure you cut the drywall straight. Score the drywall will a utility knife and then break off the excess.

Attach the drywall so there are as few seams as possible and the pieces are as close together as possible. Start from the top and move down so that most of the horizontal seams are at the bottom. Make sure all your screws and nails are flush (if not a bit indented) with the drywall. Once it is hung, use the drywall tape to cover over the seams.

Use a putty knife to apply the compound and smooth it out. Wait 24 hours and apply another coat and repeat this two more times. For finishing, use a putty knife and sandpaper to make sure the wall is smooth.

Being particularly passionate about drywall ceiling finishing, Kurt Schefken is writing different articles in the field. You can see his articles on drywall finishing tools over at http://www.insidewoodworking.com/drywall/index.html and many different sources for drywall finishing tools knowledge. Article Source: http://EzineArticles.com/?expert=Kurt_A._Schefken